DREMEL 108 Engraving Cutter

To perform best results of Dremel 108 Engraving Cutter, Dremel recommend users:

• Insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
• Secure objects to a stable surface while working.
• Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
• Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
• If chattering occurs, increase speed. 

• Shank diameter: 3.2 mm
• Working diameter: 0.8 mm
• Maximum RPM: 35,000 1/min

 *There are options for walk-in purchases.
*We always try to keep the item in stock all the time.
=========================================
 
Contact Information:
 
Balakong:
017-3691406,inquiry.kasb@gmail.com
017-3691038,inquiry.kasb@gmail.com
603-89623888   
603-89617328
 
Setapak:  
016-6616801(whatsapp)  
016-6613186(whatsapp), inquiry.kasb@gmail.com
012-9380198, inquiry.kasb@gmail.com
603-40219399  
        
Gombak:
603-40318686(whatsapp)
016-7166820, inquiry.kasb@gmail.com
016-6616081, inquiry.kasb@gmail.com
 
Titiwangsa:
012-9380198, inquiry.kasb@gmail.com
603-40319292
 
Kajang:
016-6613186(whatsapp) Tel:017-3691038
 
Knight Auto Sdn Bhd (Since 1999)(476359-M)  
A Wholly-Owned Subsidiary of Lim Seong Hai Capital Berhad
http://www.knightauto.com.my
=========================================